ChillX 5 - 16 Ton Geothermal Pond Loop Heat Exchangers

These very rugged pond loop heat exchangers come in capacities from 2 Ton up to 16 Ton, and can come with a handful of optional upgrades upon request.

These pond loops are primarily used as the heat rejection system for water-cooled chillers, and water-source heat pumps, but with the right conditions they can also be used as a very simple and efficient fluid cooler. Whatever the application, the heat is rejected through very heavy gauge copper piping utilizing rivers, lakes, and ponds. No more need to sink unwieldy slinky loops! These are trivially easy to install and attach easily to docks, bulk heads, or can simply be sunk to the bottom. We can build them to accommodate just about any connection requirement upon request.

Designed for all geothermal units using a close loop system. Save on labor cost. All units are pressure tested.

Features

• Closed-loop design.
• Hand assembled with annealed "hard drawn" copper runs for a very long and reliable service life.
• Heat exchanger bends are made from slightly softer copper to allow for easier serviceability should the heat exchanger sustain a freeze or over-pressure event -- failure points would ideally be at the ends where the ends can be easily reached and replaced.
• 1-1/2" FNPT connections standard -- other connection sizes and types available upon request.
• Can be easily shared among multiple heat sources.
• Ideal for offloading saturated geothermal ground loops.
• All units are pressure tested well beyond standard operating conditions.
• Lifetime Limited Warranty.